Filter
Top Products
26
© 2008 Directed Electronics. All rights reserved.
Runtime check
Command
: While the remote start is running, press two-times, and then
Hold for 1.5 seconds.
Feedback
4EXTREADSRUNTIMEANDDISPLAYSTIMELEFT
Notes
: This feature is only available on the 2way remote.
Runtime reset
Command
: While the remote start is running, press one-time and then
.
Feedback
: Remote start ON tones.
Notes
: Re-starts the remote start runtime counter if remote start is ac-
tive. Note: If remote start is not active, the 2-WAY remote will
respond with error tone.
Rear defogger
Command
: Press four times, and then . (Only after remote start is
on.)
Feedback
: $EFOGGERICONAPPEARSONREMOTEANDTEXTREADS$EFROST/N
Notes
: While the remote start is running the defroster will manually be
turned on for one remote start cycle. When the remote start
shuts down, the defroster will work normally. The defroster turns
on when the temperature inside the vehicle is 55 degrees or
below when this feature is wired and enabled.
Smart start
Command
: Press three-times and then press .
Feedback
: The parking lights flash 5 times fast and 'Smart Start On" dis-
PLAYSINTHETEXTAREA