Viper 5501 Automobile Electronics User Manual


  Open as PDF
of 48
 
17
© 2008 Directed Electronics. All rights reserved.
Points to remember
:
If the hood is open or if the brake pedal is pressed, the vehicle will not remote
start.
The remote start shuts down:
When the brake pedal is pressed.s
The hood is opened.s
When the remote start command is sent again from a remote control.s
7HENTHERUNTIMEEXPIRESs
To drive your vehicle after it has been remote started:
'ETINWITHOUTSTEPPINGONTHEBRAKE1.
Insert the ignition key and turn it to the ON position.2.
Now, step on the brake. 3.
The remote control will play the remote start shutdown tone. You have now
taken direct control from the remote start system.
Valet Take-Over
4HE6ALET4AKE/VERFEATUREALLOWSTHEVEHICLETOREMAINRUNNINGAFTERTHEKEY
has been removed from the ignition. This feature is useful for occasions when
YOUWISHTOEXITANDLOCKTHEVEHICLEFORSHORTPERIODSOFTIMEBUTWOULDLIKETO
leave the motor running and the climate controls on.
4OENABLE6ALETTAKEOVERWHILETHEVEHICLEISRUNNINGPRESS 1 time and the
parking lights will flash after a couple of seconds turn off the ignition and the
CARSHOULDSTAYRUNNING/NCEYOUEXITTHEVEHICLEYOUCANLOCKTHESYSTEMAND
the car will remain running. If the vehicle shuts down, then the unit did not enter
valet take-over mode.
 previous next