Viper 5501 Automobile Electronics User Manual


  Open as PDF
of 48
 
22
© 2008 Directed Electronics. All rights reserved.
Additional remote start features
Manual transmission
If the vehicle has manual transmission the proper steps must be followed before
leaving the parked vehicle or the remote start feature is disabled.
Make sure the engine is running and the doors are closed. 1.
Put the transmission in neutral.2.
Press on the vehicle’s foot brake.3.
Apply the emergency brake.4.
Release the vehicle’s foot brake. 5.
Note:
Pressing the brake again after this
step will disable the remote start feature.
Within 15 seconds activate the remote start from the remote.6.
The parking lights will flash 5 times confirming that the remote start is ac-7.
tive. If the parking lights don't flash, then repeat steps 1 - 6.
Turn off the ignition (the car should stay running when key is turned off).8.
%XITTHEVEHICLEANDCLOSETHEDOOR9.
Lock the doors with the remote. (the vehicle shuts off when locking the 10.
system).
9OUCANNOWREMOTESTARTTHEVEHICLE)FADOORISOPENEDBEFORETHENEXTREMOTE
start activation the system will not remote start.
Note:
4OENABLE6ALETTAKEOVERWITHAMANUALTRANSMISSIONOPENTHEDOORAND
enter into manual transmission mode, as described above. The parking lights
mASHONETIMEWHENENTERING6ALETTAKEOVER/NCEYOUEXITTHEVEHICLEYOUCAN
lock the system and the car will remain running. If the vehicle shuts down when
locking, then the unit did not enter valet take-over mode.
 previous next