Filter
Top Products
33
©
1999 Directed Electronics, Inc.
QUICK REFERENCE GUIDE:
To arm using your remote
■ You can activate, or arm, the system by pressing of your transmitter
for one second. When the system arms, you will hear a short siren sound,
or chirp, and see the parking lights flash once. If the vehicle’s power door
locks have been connected to the system, the doors will lock.
To disarm using your remote
■ To disarm the system, press . You will hear two chirps, and the park-
ing lights will flash twice. If power locks are connected to the system, the
doors will unlock. If the siren chirps either four or five times when dis-
arming, see Diagnostics section. This is called Tamper Alert.
Arming while driving
■ Press on your transmitter while the vehicle is running. The system
will chirp once and then once more to indicate that the ignition is on.
Disarming without a transmitter
■ Turn on the ignition. Push the Valet
®
switch the programmed number of
times within 15 seconds. The system should now disarm. If it does not,
you may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet
®
Mode
■ Turn ignition to "run" position, then turn to "off" position. Press and
release the Valet
®
switch within 10 seconds. The status LED will light solid
if you are entering Valet
®
Mode, and it will go out if you are exiting Valet
®
Mode.
To activate Panic Mode
■ Press and hold down for 1.5 seconds.
To exit Panic Mode
■ Press on the transmitter.
To activate Silent Mode
™
■ Press briefly before arming or disarming, and the confirmation
chirp(s) will be eliminated for that one operation only.
Location of Valet switch__________________________________
Number of Valet switch pulses for disarming_________________
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂✂
✂✂