93
MAINTENANCE AND LUBRICATION
PVT System
WARNING
Failure to comp ly with the instructions in this warning can result in
severe injury or death.
Do not modify any component of the PVT system. Doing so may
reduce its strength so that a failure ma y occur at a high speed.
The PVT system has been precision balanced. Any modification
will cause the system to be out of balance, creating vibrati on and
additional loads on components.
The PVT system rotates at high speeds, creating large amounts
of force on clutch components. Extensive engineering and
testing has been conducted to ensure the safe ty of this produc t.
However , as the owner, you have the following responsibilities to
make sure this system remains safe:
Always fo llow all reco mmended maintenance procedures. See
your dealer as outlined in the owner’s manual.
This PVT system is intended for use on Polaris products only. Do
not install it in any other product.
Always make sure the PVT housing is securely in place during
operation.
PVT Drying
There may be some instances when water is accidently ingested into
the PVT system. Use the following instructions to dry it out before
operating:
1. Remove the drain plug and allow the water t o drain. Replace the
drain plug.
2. Start the engine and shift the transmission into park. Apply varying
throttle for 10-15 seconds to expel t he moisture and air-dry the belt
and clutches. Do not hold the throttle wide open for more than 10
seconds.
3. Allow the engine RPM to settle to idle speed, then shift the
transmission to the lowest available range.
4. Test for belt slippage. If the belt slips, repeat the process.
5. Take the vehicle to your dealer for service as soon as possible.