Filter
Top Products
98
MAINTENANCE AND LUBRICATION
Cleaning and Storage
Stor age Tips
CAUTION
Starting the engine during the storage period will disturb the
protec tive film created by fogging and damage could occur. Never
start the engine during the storage period.
Clean the Exterior
Make necessary repairs and then clean the ATV thoroughly with mild
soap and warm water to remove all dirt and grime. Don’t use harsh
detergents or high pressure washers. Some detergents deteriorate rubber
parts. Use dish soap type cleaners only. High pressure washers may
force water past seals.
Stabilize the Fuel
Fill the fuel tank. Add Polaris C arbon Clean Fuel Treatment or Polaris
Fuel Stabilizer. Follow the instructions on the container for the
rec ommended amount. (Carbon clean will also r educe the possibility of
bacte rial growth in the fue l system.) Allow 15-20 minutes of ope ration
for the stabilize r to dispe rse through the fue l in the tank.
Oil and Filter
Warm the engine and change the oil and filter.
Air Filter / Air Box
Inspe ct and clea n or r eplac e the pre-c leane r a nd air filter. Cle an the air
box and drain the sediment tube.
Fluid Levels
Inspect the following fluid levels and change if necessary: front and
rear gearcases; transmission and brake fluid (change every two years or
as required if fluid looks dark or contaminated).