Univex 2008 Frontier Automobile User Manual


 
REAR SLIDING WINDOW (if so
equipped)
Squeeze the handles of the lever
1
, then slide
the window open
2
.
Sliding the moonroof
To fully open the moonroof, push the switch to-
ward DOWN/OPEN
1
.
To fully close the moonroof, push the switch
toward UP/CLOSE
2
.
To open or close the moonroof part way, push the
switch in any direction while the moonroof is
sliding to stop it in the desired position.
Tilting the moonroof
Close the moonroof by pushing the switch to-
ward UP/CLOSE
2
. Release the switch, then
push the UP/CLOSE switch again to tilt the
moonroof up.
To tilt the moonroof down, push the switch to-
ward DOWN/OPEN
1
.
Auto reverse function (when closing or
tilting down the moonroof)
The auto reverse function can be activated when
the moonroof is closed or tilted down by auto-
matic operation when the ignition key is in the ON
position or for about 45 seconds after the ignition
key is turned to the OFF position.
Depending on the environment or driving
conditions, the auto reverse function may
be activated if an impact or load similar to
something being caught in the moonroof
occurs.
WARNING
There are some small distances immedi-
ately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., inside
the vehicle before closing the moonroof.
WIC0856 WIC0882
MOONROOF (if so equipped)
2-46 Instruments and controls
REVIEW COPY—
2008 08+ Truck/Frontier (fro)
Owners Manual—USA_English (nna)
06/30/07—debbie