Filter
Top Products
21
( 5 ) SYNC
When an external sync signal is input, the display menu changes from INT (internal sync) to EXT (external
sync) automatically.
(5. 1) Adjusting horizontal phase
1
Set the "→" to H PHASE by pushing [MENU UP], [MENU DOWN] buttons.
2
Adjust the horizontal phase by pushing [DATA UP], [DATA DOWN] buttons.
(5. 2) Changing RGB SYNC
1
Set the "→" to RGB SYNC by pushing [MENU UP], [MENU DOWN] buttons.
2
Select G ON, ALL ON or ALL OFF by pushing [DATA UP], [DATA DOWN] buttons.
( 6 ) OPTION
• H PHASE -100 to 100
• RGB SYNC G ON, ALL ON, ALL OFF
• Sync system display
-- SYNC --
MODE EXT
H PHASE
0
RGB SYNC
G ON
Move up down
By pushing
MENU UP, DOWN
Set by pushing
DATA UP, DOWN
• RS232C baud rate 9600, 19200
-- OPTION --
BAUD RATE
9600
Move up down
By pushing
MENU UP, DOWN
Set by pushing
DATA UP, DOWN
(6. 1) Changing RS232C communication baud rate
1
Set the "→" to BAUD RATE by pushing [MENU UP], [MENU DOWN] buttons.
2
Select either 9600 or 19200 by pushing [DATA UP], [DATA DOWN] buttons.
2004.04.05, 8:51 AMPage 21