Filter
Top Products
Snow Plow Operation Section 3-3
OPERATION
The Push Arm Stop height is controlled with the 3-point hitch control lever. Follow the
instructions for this control is the tractor operators manual. The 3-point should be set in
its lowest position. With the 3-point in its lowest position, adjust the 3-point arms so that
the Push Arm Stop is level to the ground
After the first day of operation, all bolts should be checked and
tightened securely. This should be done periodically to ensure the bolts do not
become loose and cause damage to the tractor or mower, or injury to the operator.
PUSH ARM STOP POSITION
TRANSPORTING PLOWS
When driving from one site to the next, the following procedure should be followed.
The Front Plow should be raised to its highest position. The chains should be
repositioned to be tight with the plow raised.
The Side Plow should be raised to its transport position. First, raise the Kingpost all the
way to its top position. Secondly, bring the plow up by contracting the swing cylinder.
Verify that the Push Arm is contacting the rubber stop on the Push Arm Stop. If the side
plow isn’t agianst the rubber stop, lower the plow a couple of feet and then raise it back
up. Recheck the position of the plow. When the plow is raised all the way up and against
the rubber stop, shut the tractor off and walk around to the back to strap the chain around
the Push Arm.