Filter
Top Products
SAFETY
Front & Mid Plow Wings Safety Section 1-10
© 2009 Alamo Group Inc.
SAFETY
MAINTENANCE AND SERVICE SAFETY INSTRUCTIONS AND
PRACTICES
Perform service, repairs and lubrication according to the maintenance section. Ensure the
unit is properly lubricated as specified in the lubrication schedule and all bolts and nuts are
properly torqued. Failure to properly service, repair and maintain this Implement in good
operating condition could cause component failure and possible serious injury or even
death.
(SG-35)
Periodically inspect all moving parts for wear and replace
when necessary with authorized service parts. Look for loose
fasteners, worn or broken parts, and leaky or loose fittings.
Make sure all pins are properly secured. Serious injury may
occur from not maintaining this equipment in good working
order.
(SNPM-01)
Inspect the entire Snow Plow before each use. Accidents may occur or damage to the
equipment may result if the Snow Plow is not maintained in good mechanical working
order.
• Check for loose bolts, worn or broken parts, pinched hydraulic hoses, and leaky or loose fittings.
• Make sure all pins are secure and safety pin equipped.
• Make sure replacement parts are the correct size and properly installed.
• Make sure all fluid levels are full and replenish as necessary.
• Make sure fuel, oil, and coolant caps are replaced and tightened.
• Check tire condition for tread wear and tire pressure at the rated PSI.
• Make sure that all safety shields and guards are attached and in good condition.
• Make sure all scheduled maintenance is up to date.
(SNPM-02)
Do not modify or alter this Snow Plow. Do not permit anyone to modify or
alter this equipment, any of its components or any Snow Plow function.
Modification can result in equipment failure and cause serious injuries to the
operator, coworkers, or bystanders.
(SNPM-03)
Use extreme care when climbing onto the equipment to perform repairs, maintenance,
and cleaning. Use proper stands and ladders to access areas that cannot be reached from
ground level. Slipping and falling off the equipment can cause serious injury or death.
(SNPM-04)
Never attempt to repair, lubricate, adjust, clean, remove obstructions or perform any other
type of service to any component while the Snow Plow is in motion or while the engine is
running. Completely shut down the engine and wait for all motion to come to a complete
stop before servicing the Snow Plow.
(SNPM-05)