Filter
Top Products
Assembly Section 2-3
ASSEMBLY
MULTIPLIER VALVE CONTROLLER MOUNTING
The Multiplier Valve Controller comes with two worm-screw ties that are used to
attach the Controller to the Tractor Joystick as shown below.
The Multiplier Valve Controller can also be attached to the tractors’ joystick by removing
the joystick handle, drilling two holes, and using the 10-32 machine screws and nylock
nuts which are provided.
MULTIPLIER VALVE CONTROLLER WIRING
The red wire coming out of the bottom of the controller should be routed inside the
tractor cab and inserted into the Tractor Auxillary Plug-in. The cable wires should be
routed through the rear window of the tractor cab to the Multiplier Valve.
Black wire: Top button on controller.
White wire: 2nd button on controller.
Orange wire: 3rd button on controller.
Green wire: 4th button on controller.
Black wire