Filter
Top Products
18
Operating guidelines
19
13. Voice Dial
Introduction
With the help of the voice control, the telephone system can be
operated through spoken commands. This section explains the es-
sential functions which can be accessed through the voice control.
Often a desired result can be reached in several ways.
The HFK itself leads you through some of the expanded functions.
If you are not sure which commands you can use in a specific menu,
say `HELP´. Then all valid commands are then listed. The HFK has
a `user training mode´ with which it can `get used to´ accents
and dialects.
For information see chapter 22.2: Voice dial.
Some voice commands can only be called up if a mobile telephone is
connected with the HFS using Bluetooth
In order to activate the voice control, please shortly touch
this field on the touch screen. The system answers with
`Head menu´. Speak after the tone clearly in the direc-
tion of the microphone.
In order to deactivate the voice control, simply touch the touch screen
shortly anew. The system answers with `Cancel´.
When there is a longer break, the system reacts with the question `Ple-
ase say a command now´ and asks `Pardon?´, if a command was
not correctly understood.
Eight seconds afterwards the voice dial will be deactivated and must be
started new on the Touch screen.
When entering voice commands, please ensure you speak naturally,
clearly and at a regular speed.
Note:
With the use of the voice control it is recommended to
turn down the volume of components which are indepen-
dent of the audio system (e.g. a navigation system) or to
switch off the broadcast of traffic jam warnings in order to
avoid unintended voice entries.
12c. Conference Mode
Introduction
The hands-free car kit provides you with the possibility of mer-
ging up to seven conversations to create a conference. This
means that all participants can talk to each other at the same
time.
If you receive a further call during an active telephone conver-
sation, you can merge both conversations into a conference.
To this end select the merge command (conference is shown
in the display).
During a conference, you have the following options
1. You can reject the active call.
(the conference ends)
2. You can activate the private mode.
(also see chapter 12a)
3. You can activate the mute.
(also see chapter 12a)
4. You can activate the keypad.
(also see chapter 12a)
If you receive a further call during a conference, you can add this to the
conference using the add to conference command or switch between
the conference and conversational partner using the swap command
(also see chapter 12b).
Please note:
The current mobile telephone networks only permit the
use of a maximum of two lines.
If you are using both lines and you receive a further call, you have the
following options:
Reject call
Accept call
Your active connection will be ended and replaced by the
new connection.