Filter
Top Products
16
Operating guidelines
17
Incoming call
Active call
12a. Accepting, making, ending calls
In order to inform the driver of an incoming call, in the display a tele-
phone symbol is shown. At the same time the name and telephone
number of the caller (if available) will be shown. The audio system is
switched to mute and the ring tone is broadcast through the loudspea-
ker of the audio system.
You can accept or reject the call using either the voice control (which
has to be activated beforehand, see chapter 22.5) or the touch
screen.
You will be asked whether you want to ‘accept’ or ‘reject’
the call.
The call can be accepted (pushing the green symbol) or
rejected (pushing the red symbol).
A call will be ended by pushing the red telephone symbol. During the
call, you have the possibility to regulate the volume of the voice of your
discussion partner through the `minus(-)´ or `plus(+)´ field.
Using this field, you access a submenu in which you are able
on the one hand to select and send DTMF tones (e.g. to check
your mailbox) and on the other to changeover into the private
mode. In this mode, your conversation will be completed via
mobile phone and is no longer audible to the other passengers in the
vehicle. In addition you have the possibility to mute the microphone,
e.g. for further inquiries with a passenger.
Note:
Please comply with the country-specific laws concerning
in-car telephone calls.
12b. Transferring Calls
Introduction
Transferring calls is to be understood as being the acceptance
of a call during a telephone call and alternating between two
conversations.
Please note:
The functions described in chapters 12b and 12c are ex-
clusively valid for incoming calls.
Please remember that your range of functions can vary
depending on the type of mobile phone. Please find the
relevant details in the instructions manual for your mobile
phone.
If you receive another call during an active telephone conversation, you
will be informed of it via an acoustic signal. You now have the option of
either rejecting the call (the red symbol) or accepting the call (the
green symbol).
If you accept the call your previous call will be put on hold. Your con-
versational partner will be indicated with gekennzeichnet.
You now have the following options
1. Using swap you can switch between your
different callers.
2. You can reject the active Call.
3. You can reject the held call.
4. You can activate the private mode.
(also see chapter 12a)
5. You can activate the mute.
(also see chapter 12a)
6. You can activate the keypad.
(also see chapter 12a)