Filter
Top Products
4
C. Starter Interrupt and Horn Relay Installation
1. Remove the screw indicated by the arrow in Figure 1
and disengage the two plastic screws indicated by
arrows in Figure 2, then remove the dash panel.
2. Locate the starter interrupt 6-pin (white housing)
connector located to the left side of the steering col-
umn behind the removed lower dash panel.
3. Disconnect the jumper connector from the plug and
insert the starter interrupt relay into the plug.
4. Locate the horn relay 6-pin (black housing) connec-
tor located to the left side of the steering column
behind the removed lower dash panel.
5. Route the horn relay harness around the fuse box.
6. If the vehicle is equipped with the VDC system, the
lower fuse box OE nut will first have to be loosened.
Then gently pull the fuse box forward and the
attachment bracket downward. Carefully slip the
harness through and then retighten the nut (See fig-
ure 3).
7. Connect the 6-pin connectors to the two relays. Pull
down and untwist harness to maximize cable length.
Since the relays are the same it does not matter
which connection is made.
8. Mount the relay bracket to the two studs with two
M6 nuts indicated by arrows in Figure 4.
Depending on vehicle type, an OE nut may be pre-
sent on one of these studs. If so, remove and discard.
Figure 1
Figure 2
Figure 4
Figure 3
39412/SUBARU (P.01-09) 8/1/00 5:40 PM Page 4