Subaru 2001 Outback Automobile User Manual


 
& Station preset
Preset buttons
! How to preset stations
1. Press the FMor AMbutton to select
FM1, FM2, FM3 or AM reception.
2. Press the
or side of the
SEEK button or tune the radio manually
until the desired station frequency is
displayed.
3. Press one of the preset buttons for
more than 1.5 seconds to store the
frequency. If the button is pressed for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all stations stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
preset stations.
. If a cell phone is placed near the
radio, it may cause the radio to emit
noise when the phone receives calls.
This noise does not indicate a radio
fault.
! Selecting preset stations
Presetting a station with a preset button
allows you to select that station in a single
operation. Up to six AM, FM1, FM2 and
FM3 stations each may be preset.
! Auto-store
Using the Auto-store function, you can
automatically store 6 stations on the
current waveband by pressing the A.S
button for more than 2 seconds. Use Auto-
store to quickly find the strongest stations,
for example when traveling through differ-
ent reception areas.
NOTE
. When you use Auto-store, the new
stations replace any stations pre-
viously stored.
. Interrupting Auto-store: If you acci-
dentally press the A.S (Auto-store)
button, you can cancel the Auto-store
function before it has been completed
as follows.
Switching to the other source
Audio 5-13
CONTINUED