27
DISASSEMBLY
Disassembly of the Magazine
• Depress locking plate through magazine floor plate and slide
magazine floor plate to the rear.
• Detach magazine floor plate to the rear.
• Remove follower spring with locking plate and follower.
CAUTION: Magazine floor plate is under spring tension. With your
thumb secure locking plate with follower spring to prevent it from
springing out.
Assembly of Magazine
• Insert follower and follower spring with locking plate into the
magazine housing from below.
• Fully depress follower spring and locking plate (Fig.29) and slide
magazine floor plate onto magazine housing from the rear.
• Push magazine floor plate forwards as far as it will go.
• Check that the floorplate is fully seated and secured in place by the
tab of the locking plate.