Filter
Top Products
11
selected so that additional ttings such as reducer or adapter
ttings are not required.
If adapter ttings are used, they must be approved steel hy-
draulic ttings meeting a minimum operating pressure rating
of 2500 psi/172 bar. Do not use galvanized pipe ttings or
black pipe ttings.
Use thread tape or pipe joint compound when installing quick
disconnect couplings to hose or tool ttings. Follow the
instructions furnished with the selected thread sealant. DO
NOT OVERTIGHTEN THE FITTINGS.
5. BATTERY
The supplied 12 Volt DC battery is a non-spillable, mainte-
nance-free battery and is fully charged.
Make sure the battery cables are tight and charging circuit
functions are operating properly.
Do not charge the battery with a standard auto-
motive battery charger. This type of charger pro-
duces a charging amperage higher than 2 amps.
Charging the battery at higher than 2 amps will
damage the battery.
If the engine runs out of gas or dies during op-
eration and the ignition switch is left in the ON or
RUN position, this could drain the battery. Make
sure the ignition switch is returned to the OFF
position.
OPERATION