Snapper 7085632 Automobile User Manual


 
21
SECTION 3 – MAINTENANCE
3.2.2. Service Engine Air Cleaner (Continued)
FIGURE 3.3
3.2.3. Check Transmission Fluid Level
1. Raise empty cargo bed and secure with prop rod.
2. Remove dipstick from top of transmission and
wipe clean.
3. Screw dipstick fully back into transmission.
4. Remove dipstick and check fluid level.
5. Add MOBILFLUID 424 to bring level to “Full”
mark on dipstick. Install dipstick and tighten
securely
6. Lower cargo bed and latch securely.
3.2.4. Check Tire Pressure
1. Use a low pressure gage to measure tire inflation
pressure.
2. Adjust tire pressure to 15 psi. front and rear. Do
Not over inflate.
3.2.5. Lubrication –Axle Couplings & Steering Pins
1. Park machine on level surface.
2. Release park brake.
3. Locate grease fitting on left axle coupling. See
Figure 3.4.
FIGURE 3.4
(Viewed from rear of machine)
4. Roll machine until grease fitting is accessible.
5. Apply (2) shots of General Purpose grease from a
grease gun
6. Repeat on right axle coupling.
7. Locate grease fitting on left & right king pins. See
Figure 3.4a.
8. Apply (4) shots of General Purpose grease from a
grease gun.
FIGURE 3.4a
3.2.6. Check Wheel Lug Nuts
1. Torque all lug nuts to 75 ft-lb.
3.2.7. Check Brakes
1. Move machine to an open area, free of obstacles,
children and others.
2. Set park brake firmly (2 or more clicks).
3. Start engine and shift transmission to Forward.
4. Using caution, gently move accelerator pedal to
approximately 1/2 speed. Hold pedal
momentarily.
5. Machine should not move. Release accelerator
pedal and allow engine to return to idle.
6. Shift transmission to Reverse.
7. Move accelerator pedal to approximately 1/2
speed. Hold pedal momentarily.
8. Machine should not move. Release accelerator
pedal and turn engine off.
9. If machine moved, Refer to Section “Adjustments
– Service Brake and Park Brake”.
WARNING
DO NOT operate machine if brakes are not
functioning properly. Adjust, repair or replace as
necessary. Contact your local authorized dealer for
assistance.
DUCK BILL
VALVE
COVER
GREASE
FITTING
LEFT AXLE
COUPLING
STEERING
KINGPIN
GREASE
FITTING
23