Filter
Top Products
. .
..
218
OPERATION
HIDDEN ALARM FUNCTION: Press the button first then within 3
seconds, press the
button to activate the Hidden Alarm Function.
The security system will arm and be in Hidden Alarm Function. The
siren or horn will be silenced even if the sensor is triggered in the armed
status.
H. PASSIVE ARMING (See Alarm Feature II-2 Programming.)
Active Arming / Disarming will allow you to operate your security system
with the remote transmitter only. This security system is equipped with
an optional Passive Arming feature, which allows the security system
to automatically arm 30 seconds after the last door is closed.
To enter Passive Arming:
1. Turn the ignition to the OFF position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for
30 seconds. If you re-open the doors, hood or trunk, the security system
LED will stop flashing. It will begin flashing again once the vehicles
entrances are closed.
3. After the 30-second timer has elapsed, the security system will
automatically ARM. The siren will [1] chirp and the parking lights
will flash [1] time and remain ON for 10 seconds.
PASSIVE DOOR LOCKING:
The vehicle doors will automatically lock after passive arming cycle has
been completed.
PASSIVE ARMING BY-PASS: While the system is disarmed, press the
button twice, the system will respond with [1] chirp and the LED will
turn ON. The security system will remain in this temporary state until
exited. To exit Passive By-pass, press the transmitters
or buttons
and the system will return to normal status.
8. Low Battery Indication:
When the power of the battery weakens, it has [2] short beep sounds
and the
icon will flash while pressing the button of the LCD screen
transceiver.
9. Set Up Fixed Count Down (Parking) Timer:
1. Press the F button first, within 3 seconds press and hold the
button for 2 seconds, the LCD screen will show the icon and timer
(ie.0:10).
2. Press the
button again showing next order time on the screen
(ie.0:20), press them again (ie.0:30) and so on.
3. The buttons will start counting down then the
icon will flash.
Note: 1. The count down period is fixed as 10 minutes, 20 minutes,
30 minutes, 1 hour, 1.5 hours and 2 hours maximum.
2. When the count down timer is showing 0:00 that means to
turn off the timer.
3. Press F button for real time indication when the timer is
counting down.
10. Out Of Range Indication:
If this feature is selected, the security system will automatically check the
range every 20 minutes after the system is armed.
1. If the user is within range, the icon will display on the LCD screen.
2. If user is out of range, it has five short beeps sounds and the
icon will disappear on the LCD screen.
LCD REMOTE CONTROL TRANSCEIVER