Filter
Top Products
18
Connecting the headphones
̈ For monitoring purposes, connect the supplied earphones or any
Sennheiser stereo headphones with 3.5 mm stereo jack plug to the
headphone output (PHONES) ³.
̈ First, set the volume control · to the lowest volume by turning it to the
left as far as possible. Then gradually turn up the volume.
Using the components
Switching the components on/off
Switching the transmitter on/off
̈ Press the ON button ¶ to switch the transmitter on.
̈ To switch the transmitter off, press the ON button until “OFF” appears on
the display.
Note:
The transmitter can only be switched off when the standard display is
shown on the display panel. Within the operating menu, the ON button
serves as the ESC (cancel) key, i.e. you cancel your entry and return to the
standard display.
After switch-off, the transmitter is in standby mode. To disconnect the
transmitter from the mains, pull out the mains connector from the wall
socket!
Switching the receiver on/off
̈ To switch the receiver on, turn the volume control Ƹ clockwise until it
clicks. The red LED » lights up.
̈ To switch the receiver off, turn the volume control Ƹ counterclockwise
until it clicks. The red LED » goes off.
Note:
y The receiver has a short switch-on delay.
y Remove the batteries or the accupack when the receiver will not be used
for extended periods of time.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
̈ Set the volume for the connected headphones to the
minimum before putting the headphones on.
³
·
¶
»
Ƹ
ew300_350_IEM_INT.book Seite 18 Freitag, 7. März 2008 8:55 08