Filter
Top Products
14
The antenna mounts consist of:
y 2 BNC extension cables (screw-in BNC socket to BNC connector )
y 2 washers
y 2 nuts
y 2 antenna holders (GA 3030 AM only)
y 4 screws (GA 3030 AM only)
To front mount the antenna of the SR 300 IEM G2 transmitter:
̈ Screw the BNC socket of the BNC extension cables to the blanking plate
ƽ using the supplied washer and nut.
̈ Connect the BNC connector to the BNC socket ƺ on the transmitter.
̈ Slide the transmitter into the 19’’ rack.
̈ Secure the rack mount “ears” to the rack.
̈ Connect the telescopic antenna to the BNC socket .
̈ Pull the end cap to extend the telescopic antenna .
To front mount the antennas of the SR 350 IEM G2 twin transmitter:
̈ Unsecure the rack mount “ears” ³ from the rack.
̈ Guide the BNC cables through the holes in the rack mount “ears” as shown
in the diagram on the left.
̈ Screw the antenna holders to the BNC sockets
using the supplied
washers and nuts.
̈ Secure the antenna holders to the handles of the twin transmitter using
two of the supplied screws respectively.
ƽ
³
ew300_350_IEM_INT.book Seite 14 Freitag, 7. März 2008 8:55 08