Filter
Top Products
................................. ,,, , ........... H ,,.............................
GAUGE WHEEL
MOUNTING
_] TO CONVERT TO BAGGING OR
DISCHARGING
LOCKNUT
318"WASHER
GAUGE WHEEL
,_/SHOULDER BOLT
FIG, 4
INSTALL MULCHER PLATE
(See Figs. 5A & 5B)
,, Install two latch hooks to mulche[ plate using screw,
washer, lock washer, and weld nut as shown,
NOTE: Pre-assernbte weld nut to latch hook by inserting
weld nut from the top with hook pointing down..
• Tighten hardware securely.
o Raise and hold deflector shield in upright position_
• Place front of mulcher plate over front of mower deck
opening and stide into place, as shown,
° Hook front latch into hole on front of mower deck..
° Hook rear latch into hole on back of mower deck.
!
CAUTION: Do not remove discharge |
guard from mower. Raise and hold
i
guard when attaching mulcher plate
and allow it to rest on plate while in
operation.
Ju,i
HOOK POINTS DOWN
WELD NUT FROM THE TOP
LOCK
WELD WASHER
NUT X SCREW
LATCH '
WASHER
MULCHER
PLATE
LOCK
WASHER
WASHER
_,.__----SCREW
FIG. 5A
LATCH
HOOK
WELD
NUT
Simply remove mulcher plate and store in a safe place.
Your mower is now ready for discharging or installation of
optional grass catcher accessory.
NOTE: it is not necessary to change blades. The mulcher
blades are designed for discharging and bagging also.
DEFLECTOR
SHIELD
LATCH
HOOKS
FIG. 5B
,/CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
TRA CTOR, WE WISH TOASSURE THAT YOU RECEI VE
THE BESTPERFORMANCE AND SA T/SFACT!ON FROM
THIS QUALITY PRODUCT
PLEASE REVIEW THE FOLLOWING CHECKLIST:
v" All assembly instructions have been completed.
,/ No remaining loose parts in carton.
¢ Batteryis properly prepared and charged (Minimum
1 hour at 6 amps)
/ Seat is adjusted comfortably and tightened securely
,/ All tires are properly inflated. (For shipping purposes,
the tires were overinflated at the factory)
,/ Be sure mower deck is properly leveled side-to-side/
front-to-rear for best cutting results (Tires must be
properly inflated for leveling)
v' Check mower and drive belts. Be sure they are routed
properly around pulleys and inside afl belt keepers
,/ Check wiring. See that all connections are still secure
and wires are properly clamped.
WHILE LEARNING HOWTO USE YOUR TRACTOR, PAY
EXTRA ATTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
v" Engine oil is at proper level,
,/ Fuel tank is filled with fresh, clean, regular unleaded
gasoline
,/ Become familiar with all controls - their location and
function. Operate them before you start the engine..
¢ Be sure brake system is in safe operating condition