Filter
Top Products
SERVICE AND ADjUSTM
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake,
Place gearshift lever in neutral (N) position_
Place attachment clutch in "DISENGAGED" position°
Turn ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped°
Disconnect spark plug wire from spark plug and place wire where itcannot come in contact with
plug.
TRACTOR
TO REMOVE MOWER (See Fig. 19)
Mower willbeeasier to remove from theright side oftractor_
• F'!ace attach ,_en',clutch in "DISENGAGE D" position..
• Move attachment lift lever forward to lower mower toits
1owestposition
• Roll belt off engine pulley.
• Disconnect clutch rod from clutch lever by removing
retainer spring.
• Disconnect anti-sway bar from chassis bracket by
removing retainer spring,
° Disconnect suspension arms from rear deck brackets
by removing retainer springs.
° Disconnect front links from deck by removing retainer
springs,.
= Raise tilt lever to raise suspension arms, Slide mower
out from under tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR, THE
R.H. AND L.H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR-
TO INSTALL MOWER (See Fig. 19)
• Raise attachment lift lever to its highest position.
, Slide mower under tractor with discharge guard to right
side of tractor.
, Lower lift lever to its lowest position.
, install mower in reverse order of removal instructions
CLUTCH
RETAINER
SPRING
ANTI-SWAY BAR
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 19
=VER
SPRING
PULLEY
RETAINER
SPRINGS
(BOTH SIDES
20