Filter
Top Products
VisionGuard 8000 - Page 5
5. The siren will chirp 3 times to indicate system has exited programming mode.
System Confirmation
The 2-way transmitter's confirmation feature allows the current vehicle status to be displayed
at any time.
To display system status:
Press and hold Button 4 until the display shows CON.
· The transmitter will beep once.
LCD Transmitter Battery Replacement
Your VISIONGAURD 8000’S Remote Transmitter uses a 1.5 volt AAA alkaline battery, which
will require replacement in time. Depending on the amount of use, the battery may last up to
two months before it needs replacement. When the battery needs replacing, the system’s
operating range will decrease, the LCD display will show only one of three bars in the battery
icon, or the display and sounds may suddenly stop and start as the battery voltage drops below
minimum.
In order to change the battery, first slide the battery door locking pin to the side. Carefully
slide the battery cover downward until it is free. While replacing the battery make sure that
the positive and negative terminals are positioned correctly, then carefully reassemble the
transmitter case.
Icon Description: