Sceptre Technologies SS1000 Automobile Battery Charger User Manual


 
- 12 -
www.SCEPTRE.com
SCEPTRE POWER BOOST User Manual
Disconnect the jumper cable when you are finished using the unit. Do not
keep them connected.
Recharging
Please use the included recharge adapter to recharge the unit.
1. Turn on the main power switch, and plug the adapter into the device DC Jack.
2. Plug the adapter to a wall socket (100~240VAC).
3. When you are done recharging, make sure to flip the main power switch to
the off position in order to save power.
4. If the unit is making a beeping sound that means you did not flip the main
power switch to the on position while recharging the unit.
Please Note:
When charging, the power level indicator will show the red light.
When the power level reaches 80%, the red and green LED will turn on at the
same time.
To quickly charge to 80% of the level, you can start your car (Reminder: your
car should be 12V system) and connect the unit to the battery of your car for
about 3 minutes.
Maintenance
To prolong the reliability of the Sceptre Power Boost unit we recommend the following:
The unit will lose power capacity even if you are not using it and turned off the
main power switch. To keep the unit’s built in battery healthy, we recommend
recharging the battery every 3 months.
Disconnect any cabling you are not using with the unit.
Cover up the large current output and cigarette lighter socket with the
included plastic cover to prevent the metal contact plates from being corrosive.
Keep the unit at a stable place with cool temperature.
To replace the fuse please do the following steps:
1. Make sure the Sceptre Power Boost is completely powered off by flipping the
main power switch to the off position.
2. Obtain a flat head screwdriver and pry open the fuse.
3. Remove the bad fuse and insert a new fuse (20A fuse).
4. Turn the unit on to see if it works with the new fuse installed.
Battery Replacement and Disposal
Replacement
The battery should last the service life of the unit. Contact the manufacturer for any
information you may need.
Disposal
This product contains maintenance free sealed, non-spillable, lithium iron phosphate
battery, which must be disposed of properly. Recycling is required, contact your local
authority for more information. Failure to comply with local, state, and federal
regulations can result in fines, or imprisonment.
To locate a free recycling program collection center near you, go to
www.call2recycle.org.
DO NOT DISPOSE OF THE BATTERY IN FIRE AS THIS MAY RESULT IN AN
EXPLOSION.