Filter
Top Products
Power Windows
The power window
switches are located on
the armrest on the driver’s
door. In addition, each
passenger door has a
switch for its own window.
Express-Down Window
The driver’s window has an express-down feature.
This switch is labeled AUTO. Press the front all the
way down and release, to lower the window all the
way down automatically.
To stop the window while it is lowering, pull the front
of the switch momentarily. To raise the window, pull
and hold the front of the switch.
Express-Up Window
On windows with this feature, pull the switch up to the
second position and release the switch to activate the
express-up feature. To stop the window as it is raising,
pull up or press down briefly on the switch again.
Programming the Power Windows
If the battery on your vehicle has been recharged,
disconnected, or is not working, you will need to
reprogram the driver’s power window for the express-up
feature to work. Replace or recharge the vehicle’s battery
before reprogramming.
To program the driver’s window, follow these steps:
1. With the ignition in ACC/ACCESSORY, ON/RUN, or
when Retained Accessory Power (RAP) is active,
close all doors.
2. Press and hold the power window switch until the
window is fully open.
3. Pull the power window switch up until the window is
fully closed.
4. Continue holding the switch up for approximately
two seconds after the window is completely
closed.
The window is now reprogrammed.
2-15