Filter
Top Products
238 Car care
Front fog lights 3
1 Undo one screw in the wheel housing.
Lower the air shield.
2 Remove the protective cover. Release
the two spring clips securing the bulb.
3 Unplug the connector.
4 Change the bulb. Try not to touch the
glass part of the bulb with your fingers.
The height of the beam can be adjusted
using a screwdriver inserted through the
hole in the lower grille adjacent to the lens.
Side marker lights
1 Slide the lens rearward so that its front
part can be pulled out.
2 Fit the new bulb.
3 When refitting, make sure that the
groove in the spring engages the plastic
edge of the bumper trim.
WARNING
• Never crawl under a car that is
supported only by a jack. Always use
axle stands.
• Refer to the information on jacks on
pages 273 and 274.
93U SM 06.book Page 238 Friday, February 18, 2005 1:15 PM