Filter
Top Products
13
RN2 Users Manual
2.2 Using the mounting bracket.
The
RN2
comes
with
a
car
mount
kit
and
a
car
charger
to
help
install
your
device
in
your
vehicle.
The
car
mount
kit
uses
a
suction
cup
on
the
windshield to
offer
flexible
mounting
options
for
the
RN2.
Warning:
Some
countries
prohibit
the
mounting
of
any
electronic
device
on
the
vehicle
dashboard.
Be
sure
to
check
your
local
laws
for
acceptable
mounting
areas
before
installing
the
car
mount
bracket.
This section shows how to install the car mount kit in your vehicle’s windshield using the suction cup.
The RN2 uses a snap on mounting cradle to use when the device attaches to the car mount. Below is the
backside view of the RN2 in the cradle.
1.
Clean
the
mounting
surface
with
a
glass
cleaner
and
a
clean
cotton
cloth.
2.
If
the
ambient
temperature
is
below
+15°C
(60°F),
you
can
warm
the mounting
area
and
the
suction
cup
(e.g.
with
a
hair
dryer)
to
ensure
a strong
suction
bond.
3.
Install
the
car
mount
on
the
selected
area.
a. Press the suction cup of the car mount firmly against to the windshield. (See Figure 2-3-1)
b. Press down the lever to fix the suction cup in place.
c. Adjust the angles of the arm to your proper viewing position.
Figure
2-3-1
4.
Mounting the device holder with your RN2.
a. Fit RN2 down in the device holder first, and then lock it using the plugs on the bottom of the
device holder. (See Figure2-3-2)
b. Firmly dock the RN2 with device holder on the car mount which has been mounted to your
windscreen.(See Figure2-3-3)