Filter
Top Products
24 A60 Installation Manual
Cleaning the Display Window
A coating is applied to the plastic window of your display. This makes it water
repellent and prevents glare. To avoid damaging this coating, the recommended
cleaning procedure must be followed.
CAUTION:
Please read these instructions carefully. Failure to follow the
correct cleaning procedure may damage your display window and
invalidate your warranty.
Recommended Cleaning Procedure
1. Power off the display.
2. Rinse the window with fresh water, to remove all dirty particles and salt
deposits.
•
Do not use any abrasive materials, including a dry cloth.
•
Do not use any cleaning solutions, polishes or sprays.
•
Do not use a jet wash.
3. Allow the window to dry naturally.
4. If any smears remain, very gently wipe the window with a clean microfiber
cleaning cloth (not supplied).
4.2 Resetting the System
You can reset the A60 display in one of three ways:
• Power-on Reset
• Settings Reset
• Settings and Data Reset
Power-on Reset
When you reset the system, at power-on the last used values are retained for all
the options, except for those listed in the following table which are reset to the
factory default each time:
Item Power-on setting
Relative Motion mode Relative
Brightness ON at 100%
87081.book Page 24 Wednesday, December 20, 2006 2:43 PM