Filter
Top Products
8
USING THE SYSTEM
ACTIVATING THE REMOTE CONTROL
You must train the system to respond to the supplied remote
control. To activate the remote control, immediately after ap-
plying power, press
DISARM
on the remote. The system
beeps twice.
If the system loses power, the system stops responding to
the remote. To reactivate it, simply press
DISARM
on the re-
mote after power is restored.
Your system can learn two remote codes if you want to add a
second remote control (RadioShack Cat. No. 49-845). To ac-
tivate a second remote control code, be sure the system is
disarmed, then hold down
ARM
for 10 seconds. The status
indicator flashes. Press
DISARM
on the new remote to acti-
vate it. The status indicator stops flashing.
ARMING AND DISARMING THE
STARTER
To disable your starter, press
ARM
on the remote control. The
indicator flashes rapidly. If you try to start your vehicle, the
engine does not crank.
To enable the starter, press
DISARM
on the remote control.
The indicator turns off. The vehicle now starts as usual.
49-851.fm Page 8 Thursday, August 19, 1999 10:56 AM