Filter
Top Products
7
2. If you are using the supplied bracket, clean the
mounting surface with denatured alcohol and allow it to
dry. Peel the backing off of one side of the double-sided
tape and press it onto the bottom of the bracket. Then
peel off the adhesive backing from the other side of the
tape and press the bracket onto the dash.
If you are mounting the indicator in the dash’s front
panel, drill a
5
/
16
-inch hole at the selected location, tak-
ing care not to damage anything behind the surface.
3. Push the supplied snap-in grommet into the mounting
surface’s hole from the front of the mounting surface
(bracket or dash panel).
4. From the back of the mounting surface, push the indica-
tor into the grommet until it snaps into place.
MOUNTING THE SYSTEM
Use the two supplied small wire ties to secure the system un-
der the dash. Secure all loose wires except the yellow anten-
na wire. Allow the antenna wire to hang down.
Grommet Indicator
49-851.fm Page 7 Thursday, August 19, 1999 10:56 AM