Filter
Top Products
16
To select the city mode, press
CITY
. The voice alert says,
“city mode,” and
C appears on the single digit display.
Note
: If you set the display brightness to dark mode, the
single digit display shows only
-. To show C or H, set the
display brightness to bright or dim mode. (See “Selecting
Display Brightness.”)
To return to the highway mode, press
CITY
again. The
voice alert says, “highway mode,” and
H appears on the
single digit display again.
Selecting Display Brightness
You can select from three levels of brightness for your ra-
dar detector: bright, dim, and dark.
Each time you turn on the detector, the display is pre-set
to full brightness. Pressing
DIM
once reduces the dis-
play's brightness by half, and the voice alert says, “dim.”
When you press
DIM
a second time, - appears on the
single digit display and the voice alert says, “dark.” While
the display is set to dark, X, K/Ka, VG-2, and SA indica-
tors do not light during an alert. Pressing
DIM
a third time
returns the display to full brightness and the voice alarm
says, “bright.”
22-1692.FM Page 16 Wednesday, September 11, 2002 8:35 AM