Filter
Top Products
103
MAINTENANCE AND LUBRICATION
Cleaning and Storage
Storage Tips
See page 108 for the part numbers of Polaris products.
Fluid Levels
Inspect the following fluid levels and change if necessary: engine oil;
transmission oil; brake fluid (change every two years or as needed if
fluid looks dark or contaminated).
Engine
1. Remove the spa rk plug and pour 2-3 ta blespoons of Premium 4
Synthetic 0W40 engine oil into the hole. Use a section of clea r 1/4”
hose and a small plastic squeeze bottle filled with the pre - me asur e d
amount of oil. NOTE: Do this care fully! If you miss the plug hole,
oil will dr ain from the spark plug cavity into the hole at the front of
the cylinder head and appear to be an oil leak.
2. Reinstall the spark plug.
3. With the ignition off, turn the engine over several times using the
recoil starter. This will ensure coverage of the piston rings,
cylinder walls and crankshaft bearings.
4. Apply diele c tric gre ase to the inside of the spark plug c ap an d install
the cap onto the plug.
5. Treat the fuel system with Polaris Carbon Clean.
6. If Polaris fuel system additive is not used, drain all fuel from the
fuel tank, fuel lines, and carburetor. Eliminate any fuel remaining
in the carburetor by running the engine until it stops.
Lubricate
Inspect all cables and lubricate with Polaris Cable Lubricant. Follow
lubrication guidelines in the maintenance section of the service or
owner ’s manual to completely grease and lubricate the entire vehicle
with Polaris Premium All Season Grease. Apply Polaris O-Ring Chain
Lube to the drive chain.
Storage Area/Covers
Set the tire pressure and safely support the ATV with the tires 1-2” off
the ground. Be sure the storage area is well ventilated, and cover the
mac hine with a genuine Pola ris ATV cover. NOTE: Do not use plastic
or coate d mater ials. They do not allow enough ventila tion to pr eve nt
condensa tion, and may pr omote corr osion and oxidation.