Filter
Top Products
55
CONTROLS AND FEATURES
Features
Exclusive AWD System (All Wheel Drive)
Engage the All Wheel Drive switch before getting into conditions
where front wheel drive may be needed. If the rear wheels are
spinning, release the throttle before turning the All Wheel Drive switch
on. NOTE: If the instrument cluster is not registering a proper gear
indication, AWD can still be enabled by pressing the mode/override
button.
Disengaging Wheel Hubs
When backing or while in All Wheel Drive and then going forward
again, the AWD hub may remain engaged. If the hub remains engaged
it can be disengaged by stopping, shifting to and moving in reverse.
Then proceed in forward again.
NOTE: If the hub remains engaged after following these instructions
return the ATV to your dealer for service.
Switches
The light switch is located on the left hand handlebar. In addition to
turning the lights on and off, it also switches the lights from Hi to Lo
on models equipped with Hi-Lo beams. NOTE: The lights will not
work unless the key is in the on position and shut off switch is in the
“run” position.