Filter
Top Products
121
MAINTENANCE AND LUBRICATION
Water Immersion
If it is impossible to take it to a dealer before starting, follow the steps
outlined below.
S Move the ATV to dry land or at the
very least, to water below the foot
rests.
S Turn the fuel valve off.
S Remove the spark plugs.
S Loosen the carburetor drain screw (1).
S Turn the engine over several times
with electric start.
S Dry the spark plugs and reinstall or
replace with a new plugs.
S Tighten the carburetor drain screw.
S Turn the fuel valve on.
S Attempt to start the engine. If neces-
sary, repeat the “drying” procedure.
S Take the machine to your dealer for
service as soon as possible, whether
you succeed in starting it or not.
If water has been ingested into the PVT
follow the procedure on page 125 to dry
out the PVT.
If your ATV becomes immersed, take it to your dealer before
starting the engine. Major engine damage can result if the
machine is not thoroughly inspected.
CAUTION
1