Filter
Top Products
45
FEATURES AND CONTROLS
Kick-Start Lever
If the battery becomes too weak to start the engine, use the kick-start
lever to start the engine until the battery is serviced.
1. Position the vehicle on a level surface.
2. Lock the parking brake.
3. Place the transmission in neutral.
1. Fold out the kick-start lever on the left side of the ATV.
2. Make sure the stop switch and main key switch are on.
3. Place your foot on the kick-start. Thrust your heel downward to
crank the engine.
NOTE: If the engine is cold, use the choke as outlined on page 48.
4. After the engine has started, fold the kick-start lever back into
place.
NOTE: A 10/12 mm wrench is provided in the tool kit for removing or
installing the lever. If not installed, make sure the rubber cap
is installed on the kick-start shaft to protect the rider. Store
the kick-start lever under the seat in the rear cab when not
installed.