Filter
Top Products
31
OPERATION
Starting the Engine
1. Always start the engine outdoors or in a well-ventilated area.
2. Sit in the driver's seat and fasten the seat belt. Secure the cab nets.
3. Apply the brakes. Engage the park brake.
4. Shift the transmission to neutral.
5. Do not press the throttle pedal while starting the engine. Turn the ignition key past the
ON/RUN position to START. Engage the starter for a maximum of five seconds. Release
the key when the engine starts.
6. If the engine does not start within five seconds, release the ignition switch and wait five
seconds. Repeat steps 5 and 6 until the engine starts.
7. Vary the engine RPM slightly with the throttle to aid in warm up until the engine idles
smoothly.
NOTICE: Operating the vehicle immediately after starting could cause engine damage. Allow the
engine to warm up for several minutes before operating the vehicle.
Stopping the Engine
1. Release the throttle pedal completely and brake to a complete stop.
2. Turn the engine off.
3. Engage the park brake.
WARNING! A rolling vehicle can cause serious injury. Always engage the park brake after stopping the
engine.
Braking
1. Release the throttle pedal completely.
2. Press on the brake pedal evenly and firmly.
3. Practice starting and stopping (using the brakes) until you're familiar with the controls.
Tip:When the throttle pedal is released completely and the engine speed drops near an idle, the vehi-
cle has no engine braking.