Filter
Top Products
29
OPERATION
Failure to operate the vehicle properly can result in a collision, loss of control, accident or overturn,
which may result in serious injury or death. Read and understand all warnings outlined in the safety
section of this manual.
Break-In Period
The break-in period for your new RANGER is the first twenty hours of operation, or the time
it takes to use the first two tanks full of fuel. No single action on your part is as important as
a proper break-in period. Careful treatment of a new engine will result in more efficient per-
formance and longer life for the engine. Perform the following procedures carefully.
NOTICE: Excessive heat build-up during the first three hours of operation will damage close-fitted
engine parts. Do not operate at full throttle or high speeds for extended periods during the
first three hours of use.
Engine and Drivetrain Break-in
1. Fill the fuel tank with fuel. Review the fuel warnings on page 12.
2. Check the oil level. Add the recommended oil as needed to maintain the oil level in the
normal (safe) operating range.
3. Drive slowly at first. Select an open area that allows room to familiarize yourself with
vehicle operation and handling.
4. Vary throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined on the daily pre-ride
inspection checklist. See page 30. During the break-in period, change both the oil and
the filter at 25 hours.
6. Pull only light loads.
7. Check fluid levels of transmission and all gearcases after the first 25 hours of operation
and every 100 hours thereafter.
8. Inspect and adjust park brake cable tension after the first 25 hours of operation and every
100 hours thereafter to ensure proper cable tension. See page 64.
PVT Break-in (Clutches/Belt)
A proper break-in of the clutches and drive belt will ensure a longer life and better perfor-
mance. Break in the clutches and belt by operating at slower speeds during the break-in
period as recommended. Pull only light loads. Avoid aggressive acceleration and high speed
operation during the break-in period.
If a belt fails, always clean any debris from the duct and from the engine compartment.
WARNING