Filter
Top Products
60
THE PERFECT FIT
Handlebar Adjustments
Use the RIDER S ELECT feature to adjust handlebar position. See
page 31. Use the following steps to adjust handlebar angle at the
handlebar block.
1. Remove the handlebar cover (A)
to expose the handlebar and the
four adjuster block bolts (B).
NOTE: If equipped, remove the
mountain bar (C).
2. Using a 7/16″ (11 mm) wrench,
loosen the four nuts (D) on the
bottom of the adjuster block (turn
handlebar to left or right for
access to back nuts).
NOTE: If necessary, pry the
blocks apart with a
screwdriver.
3. Adjust the handlebar to the desired height. Be sure handlebars,
brake lever and throttle lever operate smoothly and do not hit the
gas tank, windshield or any other part of the machine when turned
fully to the left or right.
4. Torque the handlebar adjuster block bolts to 11-13 ft. lbs. (15-18
Nm).
NOTE: Torque the front bolts first.
5. Reinstall the handlebar cover.
A
B
D
C