Filter
Top Products
111
MAINTENANCE
Brakes
n
Hydraulic Brake Inspection
Inspect the brake lever reserve before each use of the snowmobile. See
page 67.
Brake pads must be replaced when the brake pad material becomes
thinner than the backing plate, approximately 1/16″ (1.5mm). A kit is
available for replacing brake pads. See your dealer.
WARNING
Brake failure during operation can result in serious injury or
death. Properly functioning brakes are vital to your safety. Be
sure the brake pads do not drag on the disc and that brake lever
travel is not excessive.
Always replace brake pads when the brake pad material
becomes thinner than the backing plate, approximately 1/16″
(1.5mm).
Brake Components
A. Brake Disc
B. Bleed Screw
C. Brake Line
D. Brake Caliper
E. Brake Pad Material -
Replace when
thickness is less than
1/16″ (1.5mm).
Excessive Lever Travel
Hydraulic brakes are
self-adjusting, but if excessive
brake pad clearance develops
bring the snowmobile to an
authorized Polaris dealer for
inspection and adjustment.
A
E
D
C
B