Polaris ATP 330 4x4 Offroad Vehicle User Manual


 
83
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
Oil and Filter Change - ATP 500 4x4
The recommended oil change interval is 100 hours, 1000 miles, or
every six months, whichever comes first. Suggested break-in oil
change is at 20 hours, 200 miles, or one month, whichever comes first.
Severe use requires more frequent service. Severe use includes
continuous duty in dusty or wet conditions and cold weather operation.
Severe use cold weather operation is all operation below 10° F. and
operation between 10° F. and 30° F. when most trips are at a slow
speed. Always change the oil filter whenever changing oil.
1. Obtain the correct oil filter and an adequate supply of oil so the oil
and filter change can be completed without interruption.
2. Position the vehicle on a level surface. Clean the area around the
drain plug at the bottom of the oil tank and the bottom of the
engine.
3. Run the engine for two to three minutes, then turn it off.
CAUTION
If the ATV is left without oil in the system for extended periods, the
oil pump may lose its prime, which could result in engine damage.
Always replace the oil and filter within a few hours of draining the
oil. Do not allow the vehicle to be without oil overnight.
CAUTION
Hot oil can cause serious burns to skin. Do not allow hot oil to
come into contact with skin.