Filter
Top Products
40
OPERATION
Starting the Engine
8. Move the engine stop switch to
RUN. Do not press the throttle
while starting the engine.
9. Turn the ignition key past the POSITION
LIGHTS ON position to engage the
starter. Activate the starter for a maxi-
mum of five seconds, releasing the key
when the engine starts.
10. If the engine does not start, release the
starter and wait five seconds.
11. Repeat steps 9 and 10 until the engine
starts.
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
12. If a warm engine has cooled to a point where it does not readily
start, intermittent use of the choke button (pulled half way out) may
be necessary. If the engine is over-choked when warm, depress the
throttle lever fully while cranking to aid in starting. Release the
throttle lever immediately after the engine starts. If the engine does
not start and all conditions are favorable, change the spark plug and
try again.
13. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm up. Vary the engine RPM slightly with
the throttle to aid in warm-up. When the engine idles smoothly,
push the choke completely in.