Filter
Top Products
99
MAINTENANCE
Vehicle Immersion
5. Loosen the carburetor drain screw.
6. Turn the ignition key past the
POSITION LIGHTS position to
engage the starter. Engage the
starter for only 2-3 seconds.
7. Dry the spark plug. Reinstall the
plug or install a new plug.
8. Torque to specification. See page
96.
9. Tighten the carburetor drain
screw.
10. Turn the fuel valve on.
11. Attempt to start the engine. If
necessary, repeat the drying
procedure.
12. Have the vehicle serviced by
your dealer promptly, whether
you succeed in starting it or not.
13. If water has been ingested into the PVT, follow the procedure on
page 105 for drying out the PVT.