Filter
Top Products
71
MAINTENANCE AND LUBRICATION
Lubrication G uide
Check and lubricate all components at the intervals outlined in the
Periodic Maintenance Chart beginning on page 66. Items not listed in
the chart should be lubricated at the General Lubrication interval.
NOTE: The a--arms and lower control arms have grease fittings, but
these components are greased “for life” at the factory. No
additional lubrication is needed.
Lubrication Guide Key
" More often under severe use
L Polaris P remium All Season Grease or grease conforming to NLGI
No. 2, such as Conoco Superlube M or Mobilegrease Special
F Use P olaris Premium U-Joint Lube every 500 miles, before long
periods of storage, or after pressure washing or submerging.
Item Lube Method
Engine Oil Polaris Premium 4 Synthetic
0W40
Add to proper level on dip-
stick.
Brake Fluid DOT 3 Only Maintain level between fill
lines. See page 36.
Transmission Oil Polaris Premium AGL Synthetic
Gearcase Lube
See page 78 (400/500)
or page 80 (600/700).
Front Gearcase Oil Premium Demand Drive Hub
Fluid
See page 79.
Front A-Arms None Greased for life at factory
Lower Control Arms None Greased for life at factory
Rear Gearcase Oil Premium A TV Angle Drive Fluid See page 81 (600/700).
Front Prop Shaft Yoke
(Fig. 1)
FGrease Grease fittings (3 pumps
maximum).
Ball Joint (Fig. 2)
"LGrease
Locate fitting on back side of
struts and grease with
grease gun.
(Fig. 1)
(Fig. 2)