Polaris 9919078 Offroad Vehicle User Manual


 
86
MAINTENANCE
Lubrication
Jackshaft Bearing Greasing
Loosen the driven clutch retaining bolt
and pull the clutch outward to expose the
bearing and grease fitting. Inject grease
into the grease fitting in the flangette
until grease purges from inside or
outside the bearing seal (may take only
two pumps). Push the clutch back onto
the shaft and replace the c lutch retaining
bolt. Torque to 18 ft. l bs. (24.4 Nm).
Driveshaft Bearing Greasing
Inject grease into the fitting on the speedometer
drive adaptor until grease purges from inside or
outside the bearing seal (approximately two
pumps).
Coupler Greasing (WideTrak)
Grease the couplers on the
driveshaft and jackshaft.
Grease points are indicated by a +.
1. Jackshaft
2. Driveshaft
3. Transmission
+
+
+
+
+
1
2
3