Filter
Top Products
43
THE PERFECT FIT
Edge Touring Suspension (ETS) Adjustments
Initial Setup an d Calibration
The following information has been compiled to assist you in tuning
your ETS to its maximum potential.
The Ride Control Adjuster (RCA)
1. Refer to the initial setup reference chart (located under the hood of
your snowmobile and on page 42) to determine the desired RCA
position.
2. To adjust, loosen the hex bolts (A) attaching the rear lower shock
cross shaft to the rail beam.
3. Using a 9/16” wrench, loosen the jam nuts (B) on the preload
bolts.
4. Adjust the preload bolts (C) t o the desired R CA position.
5. Ti ghten the jam nuts (B).
NOTE: Make sure the preload bolt contacts the slide block before
tightening the jam nut.
6. Ti ghten the hex bolts (A) and torque to 35 ft. lbs. (47 Nm).
NOTE: The RCA setting is the primary rear suspension adjustment.
It will have the MOST effect on rear suspension performance.
Front Arm Mounting Holes
There a re also
two front arm
mounting holes in
the slide rail that can
adjust ski pressure. The
lower hole (C) increases ski
pressure while the upper hole (D)
decreases ski pressure.
A
B
C
C
D