Polaris 800 Dragon IQ Offroad Vehicle User Manual


 
36
FEATURES
Instrumentation
MFD Digital Display Programs
Engine Program
Altitude (if equipped)
The rider can calibrate the altimeter for current
atmospheric conditions. Altimeter accuracy
will be +/-300 ft. (91 m) after adjustment.
TIP:Press and hold the MODE switch for ten sec-
onds to switch between standard and metric
units of measurement. When "ALt" displays,
the program is in the metric mode.
1. Enter the Engine Program and select the altimeter display.
2. Press and hold the SET button for five seconds.
3. When the digits begin to flash, press the SET button once to
advance 50 feet (15 m), or press and hold the button to advance 100
ft. (30 m) every 0.1 seconds. Adjust the altitude display to within 50
ft. (15 m) of current altitude.
TIP:The gauge reads barometric pressure and allows the rider to compensate
for daily fluctuations in air pressure. The gauge can adjust the displayed
altitude to +/- 1300 ft. (396 m) from the preset value. It will adjust up to
+1300 ft. (396 m) above the calibrated altitude. Once the +1300 ft. (396 m)
offset has been reached, the next adjustment is -1300 ft. (396 m) from the
calibrated altitude, and 50 ft. (15 m) will be added to the altitude each time
the SET button is pressed.
4. Press the MODE button to hold the reading at the adjusted value. If
it's not pressed within five seconds, the gauge will automatically
save the new setting.