Filter
Top Products
105
MAINTENANCE
Clutch System
Drive Belt Installation
1. Drop the drive belt over the
drive clutch and pull back the
slack.
2. To ensure satisfactory belt
life, install belts so they oper-
ate in the same direction of
rotation by positioning the
identification numbers so
that you can read them. If
required, separate the
sheaves as outlined in the
belt removal procedures.
3. Rotate the L-wrench counterclockwise to tighten the sheaves while
working the belt to the outer edge of the sheaves.
4. Remove the L-wrench and store it in the tool kit.
5. Reinstall the side panel.
6. Close and secure the hood.
To r q u e S t o p
Periodically check torque stop clearance.
With clutches in proper alignment, the
torque stop clearance should be .010I-
.030I (.25-.75 mm) from the engine case.
Adjust if necessary. Lock the jam nut.
.010I-.030I
(.25-.75 mm)