Filter
Top Products
31
FEATURES
Instrumentation
MFD Settings
With the engine running, use the
MFD Control Switch (1) to set the
MFD display to your preference.
The rocker switch has a MODE
button (2) and a SET button (3).
Standard vs. Metric
The MFD will display either
standard or metric units of
measurement. While viewing a
screen that displays measurements
(MPH, KPH or temperatures), press and hold the MODE switch until
the unit of measurement changes (about 10 seconds).
Speedometer/Tachometer
The speedometer and tachometer can be viewed in either the analog or
the digital display. If the analog display is set to show speedometer
readings, the digital screen will automatically display the tachometer
(option 1). If the analog is set to show the tachometer, the digital
screen will show the speedometer (option 2).
To change preferences, press and hold the MODE button for three
seconds. When the button is released, the new setting becomes active
and screen colors change. See table below.
Option Analog
Display
Digital
Display
Analog
Screen
Digital
Screen
1 Speed RPM Blue “mph” Blue
Backlight
2 RPM Speed Red “X100rpm” Red
Backlight
1
2
3