Filter
Top Products
85
MAINTENANCE
Clutch System
n
Drive Belt Deflection
Measure belt deflection with both
clutches at rest and in their full
neutral position.
Place a straight edge on the belt (A)
and apply downward pressure while
measuring at point B. This
measurement should be 1 1/4”.
Drive Belt Adjustment
1. Loosen the 7/6” jam nut on the belt width adjuster.
2. Using a 1/8” Allen wrench, adjust the threaded set screw (C) as
needed.
NOTE: Turn the set screw in (clockwise) to increase the distance between
the s heaves and out (counterclockwise) to decrease the distance.
3. Tighten the jam nut.
Clutch Center Distance
See your Owner’s Manual Supplement for recommended center
distance for your machine. If adjustment is necessary, see your dealer.
Due to tolerances in belt length, it may be necessary for your dealer to
make minor adjustments in the driven clutch to achieve correct belt
tension.
A
B
C